Plan to buy affordable reducing tee with male thread iron fittings BS standard ? Decho online can offer you reducing tee with male thread iron fittings BS standard , popular in Middle East , Asia and European countries. Shop Now !
The threaded fitting with one inlet and two outlets or two inlets and one outlet with BS standard male thread in malleable iron is used to connect three pipe lines with different nominal diameter and to make the pipe line in 90°or 180°bending.The reducing service tee is suitable for medium and low pressure pipeline systems, whose nominal pressure is not exceeding 2.5 MPa and working temperature range is between -20 °C and 120 °C
REDUCING TEE WITH MALE THREAD IRON FITTINGS BS STANDARD
1. Description of Products
The threaded fitting with one inlet and two outlets or two inlets and one outlet with BS standard male thread in malleable iron is used to connect three pipe lines with different nominal diameter and to make the pipe line in 90°or 180°bending.
Dimensions:
21/2” X1”(DN65X25)
Design Standard:
ENTERPRISE STANDARD
Connection Standard:
ISO 7/1, GB/T 7306.2
Working Pressure:
PN16
Application:
The reducing service tee is suitable for medium and low pressure pipeline systems, whose nominal pressure is not exceeding 2.5 MPa and working temperature range is between -20 °C and 120 °C. It is mainly applied in water, oil, air, gas, steam system, etc.
Material of Matching Products:
Q195, EN10255
Surface Treatment:
□Black
□Hot-dip galvanizing
□Hot-dip galvanizing+ Electroplated zinc
□Epoxy power painting
□Electroplated zinc
□Others would be available upon clients’ detailed request
2. DIMENSIONS
3. Performance
1) All fittings shall comply with the maximum permissible working pressure and temperature range given in the table. The pressure value between 120 °C and 300 °C is determined by linear interpolation. The normal temperature of the pipe is not lower than -20 °C. When used outside the specified pressure and temperature range, it should be negotiated with the manufacturer
2) The inside of the pipe fittings shall be able to withstand an air pressure of not less than 0.5 MPa, and the pipe fittings shall be completely immersed in the water tank for visual inspection without
